NBN ISO 4954:2021

This document specifies requirements for non-alloy and alloy steels that are intended for cold heading
or cold extruding and are delivered as wire rods, wire or bars. It also contains specific requirements for:
— steels not intended for heat treatment, with diameters from 2 mm to 100 mm (see Annex A);
— case-hardening steels with diameters from 2 mm to 100 mm (see Annex B);
— steels for quenching and tempering, including boron alloyed steels (see Table C.3), with diameters
from 2 mm to 100 mm (see Annex C );
— stainless steels with diameters of 0,8 mm up to 50 mm for austenitic steels, up to 25 mm for ferritic
steels and up to 100 mm for martensitic steels (see Annex D).
This document (except Annex A) is applicable to the properties of cold-headed or cold-extruded parts
which have been subjected to a subsequent heat treatment. As the properties of the parts in the cold-
headed or cold-extruded, and subsequently not-heat-treated condition, are largely dependent on the
applied cold-heading or cold-extruding conditions, these are, if necessary, subject to agreement between
the purchaser and the manufacturer of the parts.
In addition to this document, the general technical delivery requirements of ISO 404 are applicable.